SpeedThru Support Documents

SpeedThru is really simple to use. But just in case you could use a wee bit of help, feel free to review the documents below:

Quick Start Card: For a quick overview on how to use the most common functions of the SpeedThru System.

Operations Manual: A detailed resource complete with how to use all of SpeedThru's cool features.

Installation Manual: A detailed resource of how to put the SpeedThru system in a restaurant including many connections to various timers, greeters and more!

Headset Registration instructions: In case you ever need it. The few simple steps to register a SpeedThru headset to the base station.

Battery Changing and Charging Instructions: Provides simple instructions on how to charge and change your SpeedThru batteries.

Alert Message Addendum: How to wire a door sensor or other switch to the base station to trigger an alert message (Message repeater must be installed).

 

Tips for laying out a new or retrofit drive thru lane:

Typical Angled Menu Board Layout: A useful diagram for customers looking to build a new drive-thru.

Typical Curbside Menu Board Layout: A useful diagram for customers looking to build a new drive-thru.

 

For installers connecting SpeedThru to timers:

SpeedThru to ERC timer instructions: Overview of how to connect our system to theirs.

SpeedThru to HyperActive timer instructions: Overview of how to connect our system to theirs.

SpeedThru to Techknow timer instructions: Overview of how to connect our system to theirs.

SpeedThru to Acclaro timer instructions: Overview of how to connect our system to theirs.

SpeedThru to FastTrack timer instructions: Overview of how to connect our system to theirs.

SpeedThru to HME System 30 timer instructions: Overview of how to connect our system to theirs.

SpeedThru to HME Zoom timer instructions: Overview of how to connect our system to theirs.

 

For installers troubleshooting wiring problems:

Advanced Technical Support: Tips and meter readings for fixing wiring problems.

Wire Specifications: Minimum specs for wire to be used with the SpeedThru system.  Installers must use separate wire for the microphone.  A "bundled cable", where the speaker connection and the microphone are shared in the same wire jacket or shield, is not allowed and will cause interference.

 

For installers:

Pre-Installation Checklist: Fill this out and send it to before an installation

Post-Installation Checklist: Fill this out and send it to after an installation

 

Vehicle detector information:

Error code F1, F2, or F3 Information on LMA-1250 error codes F1, F2, or F3

EDI LMA wall plug/mount: How to connect wires to  the EDI 200/1250 vehicle detector

EDI LMA-1250: EDI vehicle detector sold with most SpeedThru systems

EDI LMA-200: EDI vehicle detector sold with older SpeedThru systems

Marsh 610: Marsh products vehicle detector

CE 317: Commercial Electronics vehicle detector

 

Drilling Through Tile?  Here's how Bob Vila does it:

http://www.bobvila.com/articles/how-to-drill-through-tile/

 

 

Need help?  Email us at